RaceClocker Button Settings

Connect the button over USB to read and change its settings. Changes are saved on the button and apply straight away.

Web Serial is not supported by this browser. Please use a recent version of Chrome or Edge on a desktop computer.
1. Device
Not connected
2. Key
The key sent each time the button is pressed.
3. LED Mode
RGB mode shows a different color for each state. Single color mode uses one color.
Single color
4. RGB Mode Colors
The color for each state. These apply in RGB mode only.
5. Buzzer
Beeps when USB connects, on each key press and during the bootloader warning.
6. Advanced Settings
For special cases. The defaults suit most buttons.
LED test at start-up
USB detection at start-up
Switching these off makes the button ready sooner. With USB detection off, the button does not wait for the computer.
Debounce time ms
How long a press must stay stable before it counts (5 to 200 ms, default 25). Raise it if one press is sometimes sent twice.
Connect the button to begin.
Console


    
Firmware versions
Firmware 2.1.0 and newer: key, LED mode and single color.
Firmware 2.2.0 and newer: also the RGB mode colors (USB detection, standby, button pressed, bootloader warning).
Firmware 2.3.0 and newer: also the buzzer on/off setting and the serial number.
Firmware 2.3.1 and newer: also the advanced settings (start-up LED test, USB detection and button debounce time).

Serial commands used
STATUS, KEY:<name>, LEDMODE:RGB|SINGLE, LEDCOLOR:<color>, RGBCOLOR:<state>:<color>, RGBCOLOR:RESET, BUZZER:ON|OFF, LEDTEST:ON|OFF, USBCHECK:ON|OFF, DEBOUNCE:<ms>

Close any other serial monitor (PuTTY, Arduino IDE) before connecting. Only one program can use the button's serial port at a time.